WE ARE CURRENTLY UPDATING OUR RAYTECH WEBSITES - SORRY FOR ANY INCONVENIENCE. TO PLACE AN ORDER, PLEASE CONTACT OUR CUSTOMER SERVICE TEAM AT 800-243-7163.
Product Categories

FAQ

Diamond Accessories

Q: Why should I invest in a diamond product over other abrasives?

Diamond abrasives are today’s state-of-the-art method of finishing. Diamond products appear more costly than conventional finishing methods utilizing carbide and oxide polishes; however, diamond provides longer life while producing faster, smoother, and overall superior results.

Q: Will more diamond abrasive applied to the surface provide faster and better results?

A: Many people believe that the more diamond abrasive applied to a surface, the better the results. In truth, an even dispersal of abrasive is the key to superior finishing, not a greater quantity. Therefore, do not attempt to “pile on” diamond abrasive. The results you achieve will be disappointing.

Q: Do I need coolant when using the Diamond Drills?

Yes, all drilling must be done under water.

Q: How long will the drill last?

A: These will last between 3 – 30 holes, depends on the hardness and thickness of the stone to be drilled.

Q: What laps are recommended for use with the Rayspray Diamond Spray?

A: All laps that are not precharged with diamond.

Q: Do I need lubricant/coolant?

A: Yes, a very light amount.

Q: Where would I use the Thinner/Lubricant?

A: This is primarily used with all unbonded diamond products such as laps and any rechargeable diamond product.

Q: Where would I use Diamond Compound?

A: This is used with any rechargeable diamond product, widely used with Rez discs and bands.

Q: How do I apply Diamond Compound?

A: Use a very small amount randomly applied, then with thinner, spread with finger to cover the entire area.

Q: How do I apply Diamond Compound?

A: Use a very small amount randomly applied, then with thinner, spread with finger to cover the entire area.

Q: What form of diamond do you use with the Rez Discs & Belts?

A: These must be used with Diamond Compound combined with Thinner/Extender fluid.

Q: What is the warm up time for the Hot Dop?

A: This takes between 15 to 30 minutes to warm for use.

Q: Is the Hot Dop good for all waxes?

A: In general, yes, however the Hot Dop will not work above 180 degrees F.

Q: What is the best way to melt waxes?

A: The Raytech Hot Dop can be used for all waxes that have a melting point below 180 degrees F.